NTN BEARING USA CORP.

angular contact ball bearings

Angular contact ball bearings feature raceways with high and low shoulders. These opposing raceways are designed to carry thrust load in one direction. NTN can preload the bearings at the factory so that the correct load will develop once the bearing is put into service. The bearings in this series are assembled with a specific internal clearance, so that they will have a specified contact angle under load. The standard contact angle used by NTN is 30° but, in many cases, a 40° contact angle can also be specified. We also offer special high-speed bearings with phenolic resin cages with a 15° contact angle.

Double row angular contact ball bearings have an inner and outer ring with a double raceway. The two rows are so related that the contact angle is similar to a pair of back-to-back single row bearings. NTN’s 5200 and 5300 series offer continuous races and can carry thrust loads in either direction. The 3200 and 3300 series have filling slots, so it is necessary to mount them with the thrust load acting against the un-notched face of the rings.

15 mm x 35 mm x 11 mm FAG HCB7202-C-2RSD-T-P4S angular contact ball bearings: Basic static load rating C0 : 490 kN; C1 max. : 43 mm

70 mm x 125 mm x 24 mm FAG HCB7214-C-T-P4S angular contact ball bearings: Accessories : No Shield, no Seal,; D : 80.0000 mm

80 mm x 125 mm x 22 mm FAG HCB7016-E-T-P4S angular contact ball bearings: Calculation factor kr : 0.33; Da max. : 887 mm

65 mm x 90 mm x 13 mm FAG B71913-E-2RSD-T-P4S angular contact ball bearings: B : 7.00 mm; Grease Speed Rating Open/Shielded n1 : 17000 rpm

100 mm x 215 mm x 82,6 mm FAG 3320-M angular contact ball bearings: d : 60.000 mm; B : 26.00 mm

240 mm x 360 mm x 56 mm FAG B7048-C-T-P4S angular contact ball bearings: Basic Dynamic Radial Load Rating C : 2810 N; Fillet Radius ra : 0.41 mm

170 mm x 260 mm x 42 mm FAG HCB7034-E-T-P4S angular contact ball bearings: Sealed Speed Rating n3 : 2600 rpm; Basic Dynamic Radial Load Rating C : 187000 N

39 mm x 75 mm x 37 mm FAG SA0020 angular contact ball bearings: Stabilizing ring : SR-10-8; Taconite seal (dc shaft position) : TER 17

35 mm x 72 mm x 33 mm FAG 548083 angular contact ball bearings: Rubber seating ring : RIS 207 A; r1,2 min. : 1 mm

65 mm x 100 mm x 18 mm FAG HS7013-E-T-P4S angular contact ball bearings: Fillet Radius ra : 2.00 mm; B : 55.60 mm

80 mm x 125 mm x 22 mm FAG HSS7016-E-T-P4S angular contact ball bearings: D : 55.0000 mm; Basic Static Radial Load Rating Co : 9650 N

10 mm x 28,14 mm x 16 mm INA ZKLR1035-2Z angular contact ball bearings: Mass housing washer : 1.11 kg; D1 : 62 mm